Control accuracy: 0.1% -3.0% (U4 parameters adjustable)
Electric actuator feedback signal which can be accessed: potentiometer 500Ω to 10KΩ
Can receive an external control signal (DC) :4-20mA (1-5V ,0-10V, switch factory custom)
Input impedance: 250 Ω;
Can be set by modifying the U1 parameters: the ① DRTA / positive action, the RVSA / action mode inverse state ② the input signal is interrupted "interrupt" mode - OPEN (open), STOP (stop), SHUT (closed)
Optional: ① The SCR output (AC, 600V, 25A)
② Relay Output (AC 250V, 10A) ◆ When ordering, specify the
The actuator position signal output: low drift output 4-20mA DC corresponding to the actuator is fully closed to fully open, the signal is completely isolated from the input (optical isolation), the output load ≤ 500 Ω
Ambient temperature :0-70 ° C, humidity :35-85%
Over-temperature protection: Locator shell temperature ≥ 70 ° C, the locator to stop the opening and closing of the actuator control
Dimensions: ZXQ2003 → 77mm (underside) x76mm (bottom wide) x51mm (H));
ZXQ2004 → 74 mm (underside length) x57mm (bottom wide) x45mm (H) calibration freely through the key input signal corresponding to the action range of the actuator (typically calibration for the electric actuator is fully closed, fully open position)
Can set upper and lower limit points
Actuator stall detection and control functions: such as control of the actuator stall stall continuous 3-4S, locator, disconnect the control output 1min; repeated measurement and control, to exclude.
Can be set to the accuracy of self-adjusting: the actuator in the course of their work, can not locate, and three times back and forth vibration locator automatic positioning accuracy down to 1/1000 (ie: the original accuracy of +1 / 1000), repeatedly adjusted to a suitable control accuracy. Set the parameters for U0 (000.x)
Lock: to prevent misuse
Anti-actuator frequent start function ● with error code indicates the cause of the malfunction (E_0X)
Intelligent step to adjust the precise positioning of the corner position of the input signal and actuator
Three. The locator panel, such as customer purchase orders specified in the configuration of this Z-(mechatronic) actuator, you do not need calibration actuator corner, the wiring is correct to normal use.
